Electrical Engineer, PCBA Test Infrastructure, Robotics

ABOUT THE TEAM Our Robotics team is focused on unlocking general-purpose robotics and pushing towards AGI-level intelligence in dynamic, real-world settings. Working across the entire model stack, we integrate cutting-edge hardware and software to explore a broad range of robotic form factors. We strive to seamlessly blend high-level AI capabilities with the constraints of physical systems to improve peoples’ lives. ABOUT THE ROLE We are seeking an Electrical Engineer for a senior individual-contributor role leading printed circuit board assembly (PCBA) test infrastructure for advanced robotic systems. You will independently turn evolving requirements into working test stations, make technical tradeoffs, and own delivery from architecture and circuit design through validation, deployment, and reliable operation. This role combines development-lab work with deployment at contract manufacturers. You will develop electrical test systems for board bring-up, programming, functional test, and characterization, partnering with mechanical, firmware, software, manufacturing, and reliability teams to carry validated stations from prototypes into repeat builds. This role is based in San Francisco, CA, and requires in-person presence 4 days a week. Travel to contract-manufacturer sites is part of the role, with timing based on build and deployment needs. IN THIS ROLE, YOU WILL: - Own PCBA test-station architecture, including device-under-test interfaces, programmable power, electronic loads, signal routing, instrumentation, and protection. - Translate board requirements and likely failure modes into test coverage, measurement methods, and pass/fail criteria. Partner with board designers on design for test, test-point access, programming interfaces, and diagnostics. - Design and bring up fixture interface boards, switching circuits, harnesses, and connectors. Release schematics, PCB layouts, wiring diagrams, bills of materials, and interface definitions. - Integrate oscilloscopes, meters, power supplies, loads, and data acquisition hardware; validate calibration, timing, accuracy, and repeatability across stations and board revisions. - Develop and debug programming and communications interfaces such as JTAG/SWD, UART, SPI, I²C, CAN, and Ethernet as required by the board. Diagnose power, signal-integrity, grounding, and contact problems. - Design and validate current limiting, power sequencing, ESD protection, interlocks, and fault recovery appropriate to the hardware under test. - Partner with mechanical engineers on probe access, connector mating, board support, cooling, and serviceability. Work with firmware and software partners to define interfaces and integrate test stations with shared software. - Write, debug, and maintain test code for instrument control, board programming, automated sequences, diagnostics, and result logging. Collaborate with software partners on reusable frameworks, code reviews, and reliable releases. - Establish station commissioning, calibration, maintenance, and configuration control. Track board identity and revision, firmware version, test limits, and station configuration with each result. - Use reference boards, independent measurements, and deliberate fault checks to distinguish board failures from fixture or software errors. Improve test coverage, false-failure rate, cycle time, and station uptime. - Own test-station deployment and acceptance at contract manufacturers, including station correlation, build support, operator training, and troubleshooting. Release configurations and documentation that keep lab and factory results consistent. YOU MIGHT THRIVE IN THIS ROLE IF YOU: - Have strong intuition for analog and digital circuits, power delivery, electronics debugging,