Maintenance Technician II

Shift: 1st Shift Hourly Rate: $28.70 Shift Differential : $1.00 Actual salary could be greater based on education, experience, and other qualifying skill sets. Carlisle Architectural Metals (CAM) is seeking a Maintenance Technician II to join their first shift team in Waukesha, WI . The Technican will maintain and repair mechanical and electrical systems within a manufacturing environment; execute capital projects (installation, dismantling of equipment) and other various maintenance tasks throughout the facility with key knowledge of the equipment and minimum supervision. Expected hours of work 40 hours a week with a varied shift schedule 8-10 hours shifts with occasional overtime and weekend hours. No travel required.  Duties and Responsibilities:   • Reassemble machines after the completion of repair or maintenance work.  • Start machines and observe mechanical operation to determine efficiency and to detect problems.  • Inspect or test damaged machine parts and mark defective areas or advise supervisors of repair.   • Lubricate or apply adhesives or other materials to machines, machine parts, or other equipment according to specific procedures.  • Install, replace, or change machine parts and attachments according to production specifications.  • Dismantle machines and remove parts for repair using hand tools, chain falls, jacks, cranes, or hoists.  • Record production, repair, and machine maintenance information within MaintainX.  • Proper work order documentation and asset state updates in MaintainX.  • Maintain PM Completion rate per Maintain X guidelines.   • Read work orders and specifications to determine machines and equipment requiring repair or maintenance.  • Set up and operate machines and adjust controls to regulate operations.  • Transport machine parts, tools, equipment, and other material between work areas and storage, using cranes, hoists, or dollies.  • Collect and discard worn machine parts and other refuse to maintain machinery and work areas.  • Clean machines and machine parts, using cleaning solvents, cloths, air guns, hoses, vacuums, or other equipment.  • Performing ongoing preventative maintenance on facility equipment.   • Repair or replace control devices such as switches, photo eyes, proximity sensors, push buttons, contactors, motor starters, etc. as needed.  • Comply and participate in regulatory, Carlisle, and departmental policies, procedures, and standards (PSM, safety protocols, COS)  • Articulate to vendors/engineer’s machine issue to resolve technical issues.  • Assist with basic electronics/ Programmable Logic Controls troubleshooting.  • Other duties as assigned.    Education and Experience:    Required:   • Education – High School diploma or GED required.  • Two to Five (2-5) years related maintenance experience; relevant Technical degree or certification.   • Must complete NFPA 70E training within 180 days of assignment.  • Previous experience in the following maintenance areas preferred: electrical, plumbing, carpentry, and welding.  • Mechanical background with rotating equipment. hydraulic and pneumatic.   • Electrical troubleshooting (motors, sensors, relays, basic PLC I/O)  Required Knowledge/Skills/Abilities:   • Knowledge of measuring gauges such as tape measures  • Knowledge and use of calipers, micrometers and digital multimeters (required)  • Knowledge of various hand and power tools  • Certified to operate a forklift.  • Working knowledge of troubleshooting electrical, pneumatic, and hydraulics. Ability to comprehend complex technical topics and specialized information.  • Effective communication and problem-solving skills  • Understanding of basic math, reading, and writing skills  • Ability to work under pressure to complete assigned tas